switch card

美 　英

• 網絡開關卡；交換卡；占位卡

例句

This is not usually specified for a switch card, but the limitation is usually a function of the trace width and connector ratings .

雖然開關卡的技術指標并不明確顯示，但是電流限值通常是走線寬度和連接器額定值的函數。

End-of-life is generally considered to be the time when the total channel resistance exceeds the specifications for the switch card.

當總通道電阻超過了開關卡的指標時，則認為使用壽命終了。

The contact resistance is the resistance across a closed pair of contacts on a switch card.

接觸電阻是指開關卡上一對閉合的觸點之間的電阻。

To measure the offset of a switch card, connect the output of the card to a pico ammeter or electrometer.

若要測量開關卡的偏移電流，請將卡的輸出連接到一臺皮安計或靜電計。

The contact potential or thermoelectric offset voltage is the key specification of a switch card designed for low voltage switching.

接觸電勢或熱電效應偏移電壓是設計用于低壓切換的開關卡的關鍵技術指標。

Contact potential is affected by changes in ambient temperature as well as by the presence of temperature gradients across a switch card.

接觸電勢受環境溫度變化以及開關卡上溫度梯度的影響。

Information about making connections to a particular switch card can be found in the card's manual.

關于連接特定開關卡的信息，請參閱開關卡的手冊。

However, this method is the least expensive because a general-purpose switch card or module can be used.

然而，由于可以使用通用的開關卡或模塊，所以該方法是最為經濟。

This may require using a high current switch card for sourcing and a low voltage switch card for measuring.

這就可能需要利用一個大電流開關卡來提供電流，一個小電壓開關卡用于測量。

Even if all this is done to the switch card, external connectors and cables can still degrade performance.

即使對開關卡采取所有這些措施，外部連接器和電纜還仍然會降低性能。

The offset current specification of the switch card should be as low as possible for switching low current.

對于切換小電流來說，開關卡的偏移電流指標應該盡可能小。

This section describes microwave switch types, RF switch card specifications, and RF switch design considerations.

本節介紹微波開關的類型、RF開關卡技術指標，以及設計RF開關時的注意事項。

Factors that affect the maximum current through the switch card include the traces on the board, the connectors, and the relays.

影響通過開關卡的最大電流的因素包括電路板上的走線、連接器和繼電器。

Switch card specifications are usually stated with a specific application in mind, such as low current or high voltage switching.

開關卡的技術指標通常是由特定的應用決定的，例如小電流或高電壓切換。

Furthermore, system hardware design contains the design of power card, vector driver card, and channel switch card.

此外，系統硬件設計還包括電源板、矢量驅動板和通道切換板。

Handle the switch card by the edges to avoid contaminating it with dirt, body oil, etc.

在拿放開關卡是要握住側邊，以防灰塵、人體油脂等對其造成污染。

Then connect the voltmeter to the HI and LO output terminals of the switch card.

然后將伏特計連接到開關卡的HI和LO輸出端子。

To prevent leakage current on the switch card, take special care when handling to prevent degradation of performance.

為預防開關卡上的漏流，在防止性能劣化時要特別注意。

To avoid switch card damage, be particularly careful when switching voltages of ~200V or higher.

為避免損壞開關卡，在切換大約200V或更高的電壓時，需要特別注意。

The connections to the switch card itself represent another source of thermally generated voltages.

開關卡的連接本身也是另一個熱電電壓源。

power is routed to the handsets by the Model 7053 High Current Switch Card.

電源通過7053型大電流開關卡路由至手機。

To ensure proper shielding, choose a switch card with shielded connectors, such as coax or triax connectors.

為確保合適的屏蔽，請選擇帶有屏蔽連接器的開關卡，例如同軸或同軸三柱連接器。

It can be found on the switch card, in the connecting cables, and in the test fixture.

在開關卡、連接電纜和測試夾具中，都會存在漏泄電流。

Refer to the instruction manual for the switch card for isolation measurement procedures specific to that card;

關于測量特定開關卡的隔離指標的步驟請參閱開關卡的說明手冊。

Industry: Group Phone; Switch; Card; Communication cable; Communications equipment agent; IP telephone;

所屬行業：集團電話；交換機；普通卡；通訊電纜；通信器材代理；IP電話機；；